| Uzytkownik FT 897 Poszukuje uzytkownika FT 897 |
| ... najpierw to se ustaw radio......... i se poczytaj głupawa instrukcje jak ustawić MENU "REAL HAMS DON’T READ MANUALS!” Ok, but at least read this one section before operating the AT-897Plus: 1. Turn off power to your FT-897 radio. 2. Connect the HF/50 MHz antenna jack on the transceiver to the “Radio” SO-239 jack on the AT-897Plus, using the supplied 50 ohm coax cable jumper. 3. Connect a 50 ohm coax antenna feedline to the “ANT” SO-239 jack on the AT-897Plus. 4. Connect one end of the supplied radio DIN-8 interface cable to the CAT/Linear port on the back of your FT-897 radio. 5. Connect the other end of the supplied radio DIN-8 interface cable to the “Radio” jack on the back of the AT-897Plus. 6. Turn on power to your transceiver. Once it powers up, hold in the FUNC key for one second to access the extended menus. Rotate the SEL knob until menu #001, “EXT MENU” appears. Rotate the dial knob until “ON” appears, to activate the extended menus. Rotate the SEL knob until menu #019, “CAT RATE” appears. Rotate the dial knob until “4800” appears. Rotate the SEL knob again until menu #020, “CAT/LIN/TUN” appears. Rotate the dial knob until “CAT” appears. Hold the FUNC key for one second again to return to normal PAGE 4 operation. 7. Select the desired operating frequency and mode. 8. Push and hold the TUNE button on the front of the AT-897Plus for one second (until the Tuning LED comes on), then release. The transceiver automatically switches to AM mode, and keys up with a minimal amount of power, and the AT-897Plus begins a tuning cycle. At the end of the tuning cycle, the original mode and power level is restored. 9. Wait for the tuning cycle to end; you’re now ready to operate! |