Kenwood ts590sg uruchomienie PTT |
sp7ivo pisze: Dokładny opis zastosowania przycisku DATA przy wyborze rodzaju modulacji: The Front Panel DATA Button When you press the DATA button on the front panel to select LSB-DATA or USB-DATA mode, you can adjust the TX and RX audio filters specifically for data operation. These settings are independent of those you would normally use for SSB voice operation. TX Data Audio Filter: Menus 27 and 28 let you select the lower and upper audio cut-off frequencies of the transmitted signal. RX Data Audio Filter: When the TS-590S is set to DATA mode, the concentric HI/SHIFT and LO/WIDTH controls on the front panel let you set up a brick-wall audio DSP filter anywhere in the audio passband. See Figure 18. • The HI/SHIFT control sets the center frequency of the filter. • The LO/WIDTH control sets the width of the filter. This gives an extremely flexible and effective method of removing unwanted signals. Bogusław sp7ivo Wlasnie tyle wyczytalem w manualu, i bylem zdziwiony ze tylko tyle. Ma to oczywiscie sens. Zafiksowalem sie w trybie ICOM |