| odblokowanie w kenvudzie ts-430s prosze o porade |
| Panowie co wy tak się spinacie? Forum jest po to aby pomagać a nie spinać się .Jak sie wie coś to się mówi , a nie zaraz bo tam jest 4W czy inne głupoty gadacie . Transmit enable for mars/cap frq for the TS-430S For MARS and CAP transmit capability, a minor change is required: 1.Unplug the DC power cable. 2.Remove the top and bottom covers of the set. 3.Locate the RF unit connector 10. Diode D39 is near the connector (labeled D39 on the circuit board). Take a small pair of diagonal cutters and clip the lead at the top of the bend. 4.Locate IC-2 on the Control Unit, under the IF unit. Resistor R148 is near IC-2, clip the resistor lead. 5.This completes the modification. Reassemble the unit, being careful not to pinch any leads. or: General coverage in transmission for the Kenwood TS-430S 1.On the the bottom board of the transceicer find the RF-UNIT (X44-1510-11). 2.Near the two plugs numbered 9 and 10 , you will see two diodes called D39 and D40. 3.Simply cut the two diodes D39 and D40 on the RF-UNIT. |