| Yaesu FT-950 pierwsze wrażenia z grup dyskusyjnych |
| Koleżanki i Koledzy mamy nowe oprogramowanie do naszych 950-tek Może ktoś na szybko co z grubsza przetłumaczyć? 10/22/12 VERY IMPORTANT NOTICE: Do not attempt to update the EDSP software on lot 43 and later FT-950 radios! This update procedure is for the FT-950 MAIN and EDSP software. The MAIN software is for all lot numbers. The EDSP software is different. Please verify the version of the radio by the serial number. The third and fourth digits indicate the lot number, example xx42xxxx. For lots 01 thru 42 proceed with MAIN and EDSP software update. For lots xx43xxxx and above install the MAIN only, DO NOT install the EDSP software. You may also verify the current EDSP level of your radio (The software versions can be displayed on the radio, see the below instructions). If the first digit of the number is 2 (example 20.45 1.13) DO NOT install this update EDSP software, It is not compatible or interchangeable with EDSP level 2 radios. The radio will no longer operate and damage may be caused to the EDSP board. Radios with lot numbers 43 and above, cannot operate with EDSP Ver. 11.54 software. At this time (10/19/2011) there are no updates for EDSP level 2 radios. Ver. 0118 MAIN CPU implements improvements (10/22/12) (This update Ver. 0117 MAIN CPU is for the FT-950 ALL lot numbers 01 to XX) ・ The KEYER BUG-key [REV] setting, when the DASH side was pressed, produced two dots, is corrected. ・ The intermittent VOX operation at AF-GAIN minimum setting of VFO-B CW mode is corrected. Ver. 11.54 EDSP implements improvements (4/5/10) (This update Ver. 11.54 EDSP is only for the FT-950 lot numbers 01 to 42) ・ Corrected FM TX for a slight frequency offset. |